Electric water heater how to clean electric water heater cleaning method

If things are used for a long time, it will inevitably produce some dirt, especially the electric products that are commonly used in our homes. Electric water heaters are one of our common products. What is the electric water cleaning method? Next we take a look at the specific electric water heater cleaning content!

Electric water heater cleaning electric water heater liner deep cleaning

1. Preparation: Power off, drain water. Here to talk about water: close the inlet valve of the triangle valve (do not let the water heater and then water) open the inlet pipe (cold water) of the discharge valve to put water, this time the hot water pipe to open, otherwise the water will not come out. The process of releasing water is very long-lasting and depends on the impurities in the bladder. If the impurities are too much, the time will be longer.

2. Remove the lid on the side of the inner side of the water heater and you can see a hole.

3, in turn remove the heater gasket, heater, thermostat.

4. Use the container to remove any residual scale from the bottom of the liner.

5, in accordance with the removal of the process of reverse reinstallation, it is important that the heater must be installed, and the seal tightly and tightly to prevent leakage. In addition, the plastic housing's thermostat knob should correspond to the thermostat's knob.

6, close the drain valve, open the inlet valve and hot water valve until the water out of the hot water pipe and then turn on the power, set the temperature control knob to the right position.

Electric water heater cleaning depth of cleaning

According to reports, water heaters need to be deeply cleaned once every 3 years. Deep cleaning requires the opening of water heater repair holes. Therefore, to ensure safety, it is best to ask a professional maintenance technician to clean it.

Simple water outlet cleaning for electric water heater cleaning

Usually, an electric water heater is designed to have a sewage outlet next to the water inlet and outlet. It may be that people do not pay attention when the electric water heater is installed. Generally, the sewage outlet will not be used, and the sewage outlet will be used only when it needs cleaning. In fact, the principle of the sewage outlet is very simple. The sewage outlet is opened and the water in the interior of the tank flows naturally. It can take away part of the deposited impurities and scale. However, there is essentially no effect on the scale attached to the inner bladder and the magnesium stick.

To clean the water heater through the sewage outlet, firstly turn off the power, turn off the inlet valve, and after the gallbladder hot water is cooled, open the sewage outlet to allow the sewage to flow out. After the sewage flows in the bladder, open the inlet valve so that the tap water flows in. The bladder flows out of the sewage outlet. After cleaning the electric water heater through the sewage outlet, it is best to disassemble the electric water heater and put it on the ground first to prevent the sewage from splashing. The drain valve is relatively inward and it is difficult to unscrew it. In addition, the author suggests that the internal scale of electric water heaters on the inside of the old year are mostly adhered to the inside of the magnesium rod and the inner bladder, and are simply cleaned through the sewage outlet. The effect is not obvious.

Regarding the electric water heater cleaning , I will introduce it to you. I hope to help you, and I would like to look forward to seeing more information on this site.

water heater